Pay in installments of $12.25 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 16 - Jul 21
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Lemon RX LM0087VP DSMP 10ch RX Telemetry, Stabilizer & Voltage ProbeHighlight The generation 2 DSMP 10 channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance. DSMX DSM2 compatible, 10 channel full range telemetry stabilizer with full telemetry features including a built in barometer, altimeter, energy meter (Current, Voltage, mAh), and internal temperature sensor High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane
Highlight
The generation 2 DSMP 10-channel telemetry stabilizer is a complete redesign that provides the ultimate reliability, features and performance.
- DSMX / DSM2 compatible, 10-channel full-range telemetry stabilizer with full telemetry features including a built-in barometer, altimeter, energy meter (Current, Voltage, mAh), and internal temperature sensor
- High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both electric and gasoline engine application
- High sensitivity gyro with proprietary stabilization algorithm ensures responsive airplane control for both electric and gasoline engine application
- BEC1 and BEC2 dual inputs allow high-reliability operation while improving setup for high current drain performance servo
- Built-in Delta, V-tail and Normal Wing mixer
- Supports stabilization with separated channel dual aileron operation
- Stabilization always-on feature allows nine usable channels on a 10-channel receiver
- Real-time variable stabilization gain control on channel 8
- All-channel failsafe
- Firmware health monitoring software stack and ultra-low operational voltage (3.6V) ensures high operation reliability
- Generation 2 SDR stack ensures the fastest channel searching and advanced algorithm for signal recovery with ultra-low-latency experience
- Antenna diversity improves the reliability of the wireless link
- Satellite port for additional signal diversity
- Gyro stabilization activation with either AUX2 or Gear channel
- 3 potentiometers for individual gain tuning
User manual
Reset stabilizer
- Connect power
- Hold F and B buttons (approximately 5 secs+) until all LED flashes randomly
- Press the C button. Multiple LEDs flash a few times to complete the operation
Bind with bind plug
- Insert bind plug on Channel 10
- Connect power
Bind without bind plug
- Connect power
- Hold the B button until the red LED flashes
Bind with a satellite without a bind plug
- Connect power
- Hold the B button until the red LED flashes
- Disconnect power
- Plug the satellite wire connector into the stabilizer
- Connect power
Failsafe
- Connect power to the receiver and ensure the servos are working with the transmitter
- Press the F button for 3 seconds until green changes from off to on and vice versa to change the failsafe setting. Channel value is saved as failsafe default at the time the green LED turns on.
- Turn off the transmitter and wait 2 seconds to ensure the failsafe is activated accordingly by ensuring there is torque generated with finger-pushing the servo linkage if it was to be set. Vice versa.
Stabilization activation switch
- Disconnect power
- Insert bind plug to channel 8
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash.
- Release the C button
- Press C to make changes within 3 seconds. Green = CH7, Blue = CH5.
- Wait for 3 seconds and remove the bind plug
Wing Mode and Dual Aileron
- Disconnect power
- Insert bind plug to channel 9
- Hold the C button
- Connect power. Wait for about 1 second until the 6 LEDs flash
- Check the receiver label/user manual to understand the referred LEDs' operation
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug
- Ensure transmitter mixing is set accordingly for dual aileron if stabilized dual aileron is to be configured.
Gyro direction
- Check the receiver label/user manual to understand the referred LEDs' operation
- Connect power and wait 1 second
- Hold the C button and wait for about 1 second until the 6 LEDs flash
- Release the C button
- Observe which red LED is flashing and brief press C to select the required mode
- Press C to toggle between settings. On means selected. Exit automatically in 5 seconds.
- Wait for 3 seconds and remove the bind plug.
V/I sensor calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected.
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Turn on the DC loading device by throttling the transmitter. Ensure 4A is drawing across the V/I sensor. Be careful with the motor spinning if it is to be used.
- Press the B button to save and exit.
V/I probe calibration
- Turn on the receiver and transmitter. The telemetry report page may optionally be checked during and after calibration.
- Plug the V/I sensor. Make sure the required DC loading device such as a brushless motor with ESC as well as the current and voltage meter is connected.
- Press the F and B buttons together at the same time for 2 seconds but no greater than 5 seconds
- Observe 3 green LED flashes. Ensure 8.4V is provided to the V/I sensor.
- Press F or C button briefly
- Observe 3 red LED flashes
- Press the B button to save and exit.
Gain setting
- Adjust via the 3 dials or real-time master gain on channel 8 depending on the transmitter channel's availability.
View setting LEDs with all on
- Press the C button briefly (no more than 2 seconds).
Lemon Rx products are tested to be compatible with Spektrum's DSMX and or DSM2 product (Spektrum, DSMX and DSM2 are the registered trademark of Horizon Hobby, Inc.).
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.7 ★★★★★
Based on 6 reviews
Sort
Product Reviews
★★★★★ 4
Small but durable
The bag is alot smaller than I anticipated it to be, and the color is not as vibrant as expected as well. The adjustable strap extends the bag to about hip level. It's pretty sturdy and the side pockets are very convenient. The zipper is a little weird, because when zipped the end sides of if the zipper don't connect with the bag, leaving small openings for items to fall out if the bag is on its side.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 11, 2022
★★★★★ 5
Awesome bag!
Color: I19004-coffee
Great bag, so hard to find a good leather bag nowadays. This is it! Love the color, the pockets and the length of the strap. It allows me to use as a cross body with ease.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 31, 2025
★★★★★ 3
Smaller then you think!
Color: Dark Brown
This purse is GORGEOUS!
I just wished it was bigger. I guess that’s my fault for not paying attention to the measurements.
Even in the pictures with the models it looked bigger
Not enough room for me so I sent it back
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 5, 2025
★★★★★ 1
Shipping department dropped the ball
Color: Dark Brown, Color: Dark Brown
I am ashamed that Amazon would claim to be an outfit that deals in luxury bags. The packaging and merchandise handlers really dropped the ball. The purse was very nice and well made. ( with the exception of the long strap 👎 ) it’s a shame this bag was tossed in the box that way I received this leather bag it was all wadded up and wrinkled in all the wrong places such as a huge wrinkle across the bottom. $139. For a bag that’s looks like it’s been in the corner of someone’s closet for months or maybe like the UPS truck ran over it. Not cool. Luxurious expensive merchandise you would expect at least a little care and packaging and handling. Disappointed
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on October 29, 2025
★★★★★ 5
Absolutely soft leather
Color: Coffee
I ordered the coffee color, absolutely love it.Super soft- I have ordered brands that cost 4xs as much & returned because of stiff leather. The zippers simply glide.I love all the different zipper pockets, I like having a place for everything, my phone fits perfectly in the back side zipper area. The front magnetic for my key fob.Zipper above to get out quick cash.I had a hard time deciding which color I wanted! It's roomy enough inside but not too big where Im going to carry things I dont need. It's nice having 2 straps to trade out- im starting with the guitar strap- like that it is adjustable straps & on swivel hooks.And you can really smell the genuine leather. For my preference I would have liked it to have been 2 to 3 inches shorter height wise as I was looking to replace a few bags I used when flying but this is perfect for an everyday crossbody.This bag looks very well made. Nothing fancy on the inside. Plan on searching for this brand in smaller size and some soft colors for spring & summer.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on February 19, 2026